Home | Troubleshooting |  Quick Setup  |  Cisco How to  |  MS-MVP  |  Wireless  |  Forums   | Site Map | Services  | Donations | Careers  | Search                           Select a Topic VPN How To Network How To Remote Access How To Windows How To Internet How To New Topics

How to configure Netgear ProSafe VPN Client using Security Policy Editor 5/9

5. Click Security Policy.

• In the right panel, choose Aggressive Mode for Phase 1 Negotiation Mode.
• Check Enable Perfect Forward Secrecy (PFS).
• Choose Diffie-Hellman Group 2 for PFS Key Group.
• Check Enable Replay Detection.

Post your questions, comments, feedbacks and suggestions

Contact a consultant

Related Topics

How to setup VPN between FVS318 and windows 2000
   Parameters Recommended for FVS318 VPN (Figure)
   Configuring the Client-to-Gateway VPN Tunnel on the FVS318v3 (Figure)
   How to configure Windows IPSec
   Difference of Tunnel Setting between local to remote and remote to local

How to check the VPN status on FVS318

• How to install Netgear ProSafe VPN Client
  How to configure Netgear ProSafe VPN Client using Security Policy Editor 1/9
  How to configure Netgear ProSafe VPN Client using Security Policy Editor 2/9
  How to configure Netgear ProSafe VPN Client using Security Policy Editor 3/9
  How to configure Netgear ProSafe VPN Client using Security Policy Editor 4/9
  How to configure Netgear ProSafe VPN Client using Security Policy Editor 5/9
  How to configure Netgear ProSafe VPN Client using Security Policy Editor 6/9
  How to configure Netgear ProSafe VPN Client using Security Policy Editor 7/9
  How to configure Netgear ProSafe VPN Client using Security Policy Editor 8/9 and 9/9
  How to test Netgear ProSafe VPN connection

Previous Page   Next Page