configure RRAS to publish one IP

The resolution 4 for Name resolution and connectivity issues on a RRAS that also runs DC, DNS or WINS

Configure the RRAS server to publish only the IP address of the local network adapter in DNS

If the Routing and Remote Access server is running the DNS service, you may Configure the RRAS server to publish only the IP address of the local network adapter in DNS.

To add the PublishAddresses and RegisterDnsARecords registry values for the DNS and Netlogon services, follow these steps:

1. Click Start, click Run, type regedit, and then click OK.

2. Locate and then click the following registry subkey:

HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\DNS\Parameters

3. On the Edit menu, point to New, and then click String Value to add the following registry value:

Value name: PublishAddresses
Data type: REG_SZ
Value data: IP address of the server's local network adapter. If you have to specify more than one IP address, separate the addresses with spaces.

4. Locate and then click the following registry subkey:

HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\Netlogon\Parameters.

5. On the Edit menu, point to New, and then click DWORD Value to add the following registry value:

Value name: RegisterDnsARecords
Data type: REG_DWORD
Value data: 0.

6. Close Registry Editor, and then restart the DNS and Netlogon services. To restart a service, click Start, point to Programs or All Programs, point to Administrative Tools, and then click Services. In the Services console, right-click the service, and then click Restart.

Post your questions, comments, feedbacks and suggestions

Contact a consultant

Previous Page Next Page