Home | Troubleshooting |  Quick Setup  |  Cisco How to  |  Data Recovery  |  Forums   | Blog | IT Exam Practice | Services  | About Us | Chicagotech MVP  | Search  | Contact Us  |                  Laptop for rent: $35 per day plus $10 for additional day

rental
 

 

How to use the EMC to create a database availability group

1. Run EMC.

2. Navigate to Organization Configuration > Mailbox.

3. In the action pane, click New Database Availability Group.

4. On the New Database Availability Group page, enter the following information for the new DAG:

Database availability group name Use this box to type a valid and unique name for the DAG of up to 15 characters. The name is equivalent to a computer name, and a corresponding Cluster Network Object (CNO) will be created in Active Directory with the name of the DAG. The name of the DAG isn't used by end users or administrators. It is used only by the system for internal communication and to secure the DAG.

Witness Server Select this check box and use the corresponding text box to specify a witness server for the DAG. If you don't select this check box, the system will attempt to automatically select a Hub Transport server that doesn't have the Mailbox server role installed to be used as the witness server.
Note:
If you specify a witness server, you must use either a host name or a fully-qualified domain name (FQDN). Using an IP address or a wildcard name isn't supported. In addition, the witness server cannot be a member of the DAG.

Witness Directory Select this check box and use the corresponding text box to type the path to a directory that will be used to store witness data. If the directory doesn't exist, the system will create it for you on the witness server. If you don't select this check box, the default directory will be created on the witness server.

5. Click New to create the database availability group.

6. On the Completion page, review the following, and then click Finish to close the wizard:

7. Click Finish to close the wizard.

Note: After you create a DAG, it will be configured to use DHCP. If you don't want the DAG to use DHCP, you can use the Set-DatabaseAvailabilityGroup cmdlet to configure one or more IP addresses for the DAG.

 

 


Post your questions, comments, feedbacks and suggestions

Contact a consultant

Related Topics

DAG Failover Cluster loosing Connection - Networking, VPN, TS ...


DAG two Node Design question - Networking, VPN, TS, Remote Access ...


Database Availability Group - Networking, VPN, TS, Remote Access ...


Exchange 2010 DAG Requirements - Networking, VPN, TS, Remote ...


Exchange 2010 DAG Copy Status: Service Down


What's Exchange DAG - Networking, VPN, TS, Remote Access and ...


What's Exchange Database Availability Group (DAG) - Networking ...


 

 


 

 

Hit Counter   This web is provided "AS IS" with no warranties.
Copyright © 2002-2018 ChicagoTech.net, All rights reserved. Unauthorized reproduction forbidden.